Review for "UM982 Dual Channel RTK GNSS receiver board with USB C and JST"

UM982 Dual Channel RTK GNSS receiver board with USB C and JST
UM982 Dual Channel RTK GNSS receiver board with USB C and JST

UM982 Dual Channel RTK GNSS receiver board with USB C and JST connectors. I2C, UART, SPI interfaces. Base, Rover or Heading operation. VOLUME SALES PRICING This product comes with 1 years worldwide warranty

Review

0 1 2 3 4
(5/5) 
By Nick Mendos on 10/11/2023 UM982 Dual Channel RTK GNSS receiver board with USB C and JST 0 of 0 people found the following review helpful
Total Rating: 0 1 2 3 4

Hello, Team Eltehs. I have a few questions.
1) The documentation says that I2C and SPI are not used, so why are there these signals on the 12pin connector and there is no e.g. uart3
2) why there is no reset signal on the 12pin connector?
3) what is the lifespan of this product? If everything works out, I will replace all Ublox F9P dual modules in my company with UM982 dual modules from you.
4) is it possible to change the signals on the 12pin connector if SPI and I2C are not connected? Do you manufacture custom pcb board?


Shop owner reply (10/11/2023):
Dear Nick
1) I2C and SPI will be supported with future firmware versions. All boards can be upgraded on the field over USB.
2) UM98x modules have reliable internal reset circuit, so for most applications it does not be need to be present on the external connector.
3) We expect that UM98x modules will be manufactured and supported in 3...5 years, than it will be replaced to the next generation. As official Unicore distributor, we will support this modules over all lifespan.
4) No problem, please describe necessary board dimensions, connectors, etc - we do custom design for many customers.
Was this review helpful to you? Yes No
 Report abuse