3. Getting started

The setup of the base station begins with selecting the connection method: via Ethernet, WiFi with WPS, or without it. Properly connecting the equipment before powering it on is crucial. Turning on the station, configuring WiFi, troubleshooting issues, and completing final steps will help finalize the installation. Additional configurations are available for earning with Onocoy or connecting to other NTRIP casters.

This section covers essential safety precautions during hardware setup, including antenna installation, SD card insertion, and differences between base station types. Follow these guidelines to avoid damage and ensure stable device operation.

This section covers Wi-Fi setup using WPS PBC for the ELT_RTKBase base station. Starting from version 1.7.8, the device supports Wi-Fi Protected Setup (WPS), allowing for quick network connection by pressing the WPS button on both the router and the device. In version 1.7.9, WPS activates only if there is no existing network connection.

This section explains the LED indicators on advanced (wired) and budget (wireless) base stations. The purple LED shows power status, while the green LED indicates satellite reception—its behavior varies by model. The yellow LED signals internet connectivity, blinking during WPS mode, and the red LED confirms a successful NTRIP caster connection.

The device should be installed in a cool, dry, and dust-free environment, avoiding direct sunlight and exposure to weather conditions. Advanced (wired) base stations support multiple mounting options, including brackets and rack panels, while budget (wireless) models are only compatible with the Rubber Feet pack.

Changing the Password Secure your account by updating your password in just a few steps. Log in, navigate to Settings, make the change, and ensure your credentials are safe.

Most users don’t need to read this section. But if your WiFi access point has no WPS button, or if you want to set a static IP address, or enable SSH access, this section is for you.

Learn how to verify GNSS satellite reception, signal strength (SNR), and PPP mode on your base station, and how to correctly configure base coordinates in the settings.